LED bulb

The white bulb can control the dimming and shades of white light. Before you can use this light bulb you have to add it to the Link. This page describes the interaction and setup of the following Led bulb; 

• Smartwares XQ-lite 868Mhz Connected LED lamp XQ1600 
• Smartwares Connected E14 candle LED lamp HW1602 
• Smartwares Connected GU10 LED lamp HW1603 

IMPORTANT

If you have bought a colour bulb go to this page

Adding The LED bulb to the link 

Before you add the bulb to the link take note of the following: 

• One at a time

You can only add one LED Bulb light at a time. Adding multiple bulbs at the same time may result in unwanted behaviour. 

• Don’t turn on the power just yet

You can install the bulb in a fitting, but do not power it on. If you have accidentally done so already don’t worry. Make sure that the power is turned off again before you start the procedure.

• Do not use a dimmer

The following steps explain how to add the bulb in the HomeWizard Link App:

1. Open the 'HomeWizard link' app 
2. Go to the  'My Home' tab at the bottom right of the screen. 
3. In the app, go to the 'Home Settings' by clicking the gear icon in the upper right corner
4. Select 'Add devices'
5. You are in the 'Add new devices' screen.
   • Select ’LED bulb’ to add a light bulb in the link.
   • If everything is well prepared, press 'next' to start the pairing process.
     • Now turn on the power of the bulb. The bulb will blink briefly when it is paired.
       • Follow the further instructions on the app.

6. Congratulations, you have added a colour bulb to the HomeWizard link.

Controlling the colour bulb in the Homewizard link app

Once added, it is possible to operate the LED bulb.

1. Open the  'HomeWizard app'  
2. At the bottom of the screen, click on ‘Control’.
3. You are in the 'control' screen. Find the LED lamp in the added room.
   • Tab once on the 'tile’ of the LED bulb to turn the light ‘ON’ or ‘OFF’
   • Hold down the ‘tile’’ of the LED bulb for a long time to ‘EDIT’.
     • Your are in the ‘Device settings’ of the colour lamp you can now edit the following functions;
       • Press “White” this change the shades of white light
         • Use the field to choose the desired white shades.
         • Press the ‘slider’ to dim to light.
       • Press  'History' to view the history of the LED bulb
       • Press  ‘Device setting’ to change the name, toggle favourite position or manage automation.